- Aircraft Engine
- Aircraft Fasteners
- Auto Parts Rebuilding
- Bearing Manufacturing
- Battery Manufacturing
- Can Factories
- Carbide Manufacturing
- Computer Components
- Die Manufacturing
- Electronic Connectors
- Glass Manufacturing
- Gear Deburring
- Hydraulic Couplings
- Motor Armature Turning
- Pneumatic Couplings
- Refinery Operations
- Rubber Grinding
- Seal Manufacturing
- Tool Manufacturing
- Utensil Manufacturing
- Wire Factories
- And many others world-wide.
CROZIER SPEED LATHE - Model 3CPL
1 HP Belt Drive, 1800 RPM, Single Speed or Variable Speed
The Crozier Model 3CPL Speed Lathe is a chuck model designed to handle the odd jobs that do not fit in a collet or for small batch jobs.
- 1 HP Belt Drive
- 6 Inch Manual Chuck (Air operated chuck available)
- 1800 RPM Single Speed or Variable Speed
- Machined Billet Aluminum Main Housing
- 6 inch 3 Jaw Chuck
- 3 Phase / 240 Volts
- Or Single Phase 120 Volts
- Self Ejecting Chuck Key
Contact Crozier For Price Quote
The unit is small enough to fit on a table. The chuck is a standard six inch design. The jaws are two piece for doing both ID and OD work. The oversized spindle runs on a double row bearings on the end with the chuck.
The Crozier Model 3CPL Speed Lathe is attached to a wooden pallet. The Speed Lathe is attached to the bottom of the container with four carriage bolts. Remove the bolts from the mounting holes. The Speed Lathe is ready for installation. Check the box for all parts. If any damage is noted call the freight company immediately. The freight company is responsible for the safe delivery of the machine and if immediate notification of damage is not reported, you might not be able to file a claim for damages.
The Crozier Model 3CPL Speed Lathe must be secured to a suitable stand at all times.
The Crozier Model 3CPL Speed Lathe is designed to operate with sealed bearings. No provision has been made for introducing grease into the bearings. Should it become necessary to change bearings only sealed bearings of electric motor quality C/3 fit with seals or shields on both sides should be used. No bearing spacers are required.
The Crozier Model 3CPL Speed Lathe input requirement is 240 Volts, three-phase power. Motor rotation is counter-clockwise, looking directly at the shaft. A qualified electrician is required to install the electrical connection. The machine must have a power disconnect placed near the machine. The electrician must run the wire through conduit from the disconnect to the control box. The incoming power is hooked up to the #1, #2, and #3 terminals. Ground is terminal #4. Make sure all connections are tight before energizing the motor.
The Crozier Model 3CPL is equipped with a manual 3-jaw lathe style chuck. The chuck operates the same fashion as a regular lathe. Make sure the part is secured in the chuck before starting the motor. Also make sure the chuck key is never left in the chuck for any reason.
As with all equipment proper care should be taken. Safety glasses must be worn at all times while operating the Speed Lathe. It is the responsibility of the end user to determine the suitability of the Speed Lathe in their application.
This machine is a precision machine tool. The components used in its manufacture are of the highest quality and the machined parts are held to very exact tolerances. If you expect the machine tool to last, you must take proper care of it.
The Crozier Model 3CPL Speed Lathe can be cycled on and off as fast as you can do the work.